I’m speechless to see a lot of people seemed to like my creation, so I’m posting the in-depth tutorial including the list of components required! I'll link as many components as possible to the aliexpress site! (cuz it ships worldwide if I'm not mistaken)
Here's the link to the STL files for both the base and the cover below! → https://makerworld.com/en/models/1132712
This needs to absolutely have 16mm of side length. It won’t fit in the base otherwise. Unless you modify the stl model yourself.
For WLED controller
This is required to draw 5v from a negotiation-based USB PD which has multiple supported voltages. BUY THIS PARTICULAR SHAPE FOR THE PERFECT FIT!!
This was the only type c power supply that outputs up to 5a. Just splicing it into positive and ground WILL NOT WORK. The USB Trigger module is required for this reason.
This is needed to screw the bottom cover to the base. Might be better to just grab it from your local hardware store than ordering it online. Allen, phillips, or hex does not matter.
This goes into the three holes on the base with soldering iron. I used 4mm height one, any will do I guess.
Up to your choice! I personally used polymaker white ASA filament because I hate how easily the PLA warps from heat. (Try not to use ASA if you do not have a heated enclosure!! It'll warp the
shit out of it!!)